bet体育足球

Customer selection feedback form of drying equipment
Please fill in the form in detail, so that our company can provide careful selection recommendation
corporate name:
*
Postcode:
Company address:
*
Customer Name:
*
Title:
Telephone:
*
Fax:
E-mail:
website:

1. Material name: Molecular formula: PH value:

2. Form of drying materials: Micropowder Powder grain lump Flaky size
filter cake Paste Paste like solution Fibrous Emulsion Suspension

3. Other characteristics of materials: flammability Explosive Agglomeration Odor others:

4. Name of evaporated medium: Molecular formula: PH value:
Boiling point of evaporated medium: Whether to recycle: Yes , No

5. Initial moisture content of material: %Among them, water is contained in the crystal
Required moisture content after drying: %The residual crystal water is required to be:

6. Initial material temperature: The temperature after drying is required to be: ℃。 Whether to use cooling material collection: Yes , No

7. Maximum temperature that materials can bear during drying: The optimum temperature range for drying materials is as follows

8. Softening temperature of materials: The melting point of the material is as follows

9. Specific heat of material: KJ / kg. ℃; thermal conductivity of material: 1 KJ/m two .h. ℃

10. True density of material: kg/m three Bulk density, bulk density: kg/m three

11. Material size distribution range: Mm (mesh) to Mm (mesh); proportion content ≥ %
Among them: maximum particle size Mm (mesh); proportion content ≥ %
Minimum particle size: Mm (mesh); proportion content ≥ %

12. Particle size requirements of dried products: Mm (mesh)

13. Viscosity of material in original state: Centipoise (CP); heating to reduce viscosity: Yes , No

14. Whether the form of material can be damaged during drying: Yes may not

15. Product output after drying: Kg / h (or wet material handling capacity: kg/h)

16. Drying method requirements: Continuous drying Gap drying Dynamic drying Static drying
Hot air drying Vacuum drying Microwave drying, others:

17. Past drying methods of materials or similar products:
Type of dryer to be used:

Air inlet requirements: 18 Natural gathering, 300000 level filtration, 100000 level filtration, 10000 level filtration, others:

19. Material requirements of users: The material contact is stainless steel All stainless steel Titanium
Aluminum alloy Carbon steel Glass lining Teflon, others:

Stainless steel to be used SUS304 , SUS321 , SUS316 , SUS316L, SUS2235 ,
other:

21. Requirements for material recovery rate: ≥ %Dust emission requirements: ≤ mg/nm3 ;
Emission requirements of waste gas environmental protection: ≤ Mg / Nm3; the maximum allowable discharge requirements of waste water and waste liquid are ≤ mg/L

22. Hot medium and heat source used in drying process: hot water C; steam MPa; heat transfer oil ℃;
Electric heating Coal fired hot blast stove Oil fired hot blast stove Gas fired hot blast stove , others:

23. Thermal medium and heat source: self provided , purchase separately Supporting procurement , others:

24. Cleaning and sanitation requirements for equipment:

25. Place of use: Altitude: , humidity: Maximum temperature:
Minimum temperature: Annual average temperature: , others:

26. Budget investment amount of purchasing equipment (RMB) Ten thousand yuan

27. Other requirements:
Verification Code: can't see clearly?
 
 
Top